i-gsm02
Page 11
Recording Voice Messages
The microphone for recording speech messages is on the i-gsm02
module, as well as a small speaker that allows you to playback the
messages.
If you intend to record speech messages, and the user’s keypad is
already fixed at some distance from the central station, you can
temporarily enable the control unit tamper switch to act as a
record/playback control as follows:
14. Start with the end station lid off and the tamper switch open.
15. At the keypad go into the
Installer Menu - Communications - Speech
Dialler - Messages
, set the
Use Lid Tamper
option to Yes, and
press
Y
.
16. At the control unit hold down the tamper switch. When the red
Record/Playback LED on the i-gsm02 glows recite your
message.
17. Release the tamper switch.
18. Pulse the tamper switch briefly.
The i-gsm02 plays back your recording.
19. Go back to the keypad and press
X
to leave “Use Lid Tamper”
mode.
Finishing the Physical Installation
Once programming is complete:
20. If you enabled the control unit tamper switch to control speech
recording and playback then leave the
Use Lid Tamper
option. (If
you do not do this then the speech dialler will record the room
sounds over your message as soon as you close the tamper
switch.)
21. Re-fit the lid of the end station.
32. Test the module using the options in the
Installer Menu - Test
option.
