4
COOPER LIGHTING SOLUTIONS
IB500110EN
Installation instructions
Installation Instructions - TopTier LED
Wall Mount (WM) Installation (Figure 9)
1.
Follow steps 1-3 for Ceiling/Junction Box installation to
remove the quick mount plate from the fixture.
2. Assemble wall mount bracket to the wall mount arm
using 3 #8 Flat head screws provided.
3. Assemble quick mount plate to the wall mount bracket
using 4 #10 screws provided.
ote:
N
Do not mount wall bracket to a junction box. Wall
bracket should be secured into the wall for secure
mounting.
Decorative Pendant Mount (DPM) Installation
1.
Mount swivel support to flush mounted junction box
(supplied by others) using the provided hardware.
2. Place fixture canopy, collar, and swivel canopy on stem.
(Figure 10.)
3. Screw (1) locknut on base of stem to top of threading.
4. Insert stem through fixture mounting bracket.
(Figure 11.)
5. Slide (1) washer and (1) locknut on to bottom of stem
and tighten a minimum of 3 full turns.
6. Tighten top locknut onto fixture mounting bracket and
snug with wrench. Feed wires through stem and make
sure they extend out the top of the pendant.
7.
Make electrical connections below stem.
8. Lower fixture canopy and collar on top of fixture
mounting bracket then fix collar in place with set screw.
9. Insert swivel ball end of stem and fixture assembly in
to swivel support.
Figure 11.
Swivel Support
Swivel Ball
Swivel Canopy
Stem
Collar
Fixture Canopy
Locknut
Washer
Fixture Mounting Bracket
Locknut
Figure 10.
Decorative Pendant Mount Option
Torque the 4
screws to 20
in. lbs.
Assemble Cover Plate
after Wiring Fixture
with #10 Screws
(3) #8 Flathead Screws
Assemble Wall
Mount Bracket
2” Diameter
(4) .28” Holes
4.75”
2.38”
Figure 9.
Wall Mount Option
10. Connect stem wires to power supply leads above
swivel support.
11. Slide swivel canopy over swivel support and twist to
engage tabs.
Maintenance
A regular maintenance schedule should be followed to
retain optimal light output and thermal performance. Optical
lens cleaning should be performed with a clean dry cloth to
remove any dust or other contaminants. Additional cleaning
can be performed with non-abrasive acrylic cleaning
solution.
