7
7
Securing the safety chains
Before securing the safety chains, check that you have completed the installation process and that all
connections have been made successfully and that the cooker is in its final operating position.
Fix the security chains to their anchor brackets:
1.
Loosen the hex nut at the unattached end of the safety chain, until it is flush with the screw end. Do not
remove it completely. (Figure 5).
2.
Insert the screwhead into the top hole of the anchor bracket by tilting it sideways so that it is at an
angle to the top hole when it is inserted. (Figure 6).
3.
When the screw head is fully engaged in the bracket, tilt it upwards so that it is straight, and tighten the
hex nut to secure the end chain link into position.
Preparation
1.
Ensure that the safety chains on the rear of the cooker is attached to its anchor on the wall behind.
2.
Remove the remnants of any stickers, glue and adhesive tape from all surfaces of the cooker and the
hotplates, with warm water and washing-up liquid.
3.
Dry the inside and outside surfaces of the cooker with a soft lint-free cloth.
4.
Turn the grill to a moderate heat (page 10) for a few minutes to burn off any dust and manufacturing
residues.
5.
Repeat the above process with the oven.
6.
When using for the first time, turn on the hotplates, one at a time, and set the temperature selector
knob to position '3'. Leave them on for about 5 minutes.
When using for the first time the oven may smell for a short time while burning off residues.
Figure 5 – loosening the hex nut
Figure 6 – securing the cooker
HEX
NUT
TOP
HOLE
ANCHOR
BRACKET
