Page 5
Interior light
FIGURE 7
The interior lamp is only available in the lower
compartment. To turn the lamp to ON press the
rocker switch to ON. To turn the lamp to OFF press
the rocker switch to OFF. The lamp must be
manually turned OFF and ON.
Replacing the lamp
Unplug the chiller from the mains supply.
Remove the screw and diffuser.
Unscrew the lamp from the lampholder and replace
it with a lamp of the same type and wattage (10
Watts).
SCREW
DIFFUSER
LAMP
LAMPHOLDER
ON/OFF
SWITCH
Maintenance and cleaning
It is recommended to clean and wipe out the chiller
after any spillage inside or outside the appliance.
Use a teaspoonful of bicarbonate of soda diluted in
a pint of warm water. Wipe the internal surfaces
and shelving to remove residues. Leave to dry
before reloading.
Keep water away from the temperature controls.
Finally, wipe the door seal.
The chiller automatically keeps a constant
temperature dependent upon the thermostat
setting. Beware of the back wall as this may be
cold to the touch.
Wipe the outside casing from time to time in order
to remove dirt and dust.
Drainage channel
Water collects in the drainage channel on the back
wall located in the lower compartment. The
drainage needs to be cleaned regularly to avoid the
build up of impurities. Wipe the channel with a
damp cloth and clean out any residue from the
drainage hole (Figure 8).
Use a soft brush or vacuum cleaner to remove the
dust from behind the chiller, taking care not to
damage the pipes and wiring.
Also remove dust from the compressor motor
housing which is situated at the rear back of the
appliance casing.
Clean the collecting tray from above the
compressor motor (rear of the casing) ensuring that
the drainage pipe is also clear.
Important
The chiller must be turned off at the mains before maintaining or cleaning.
FIGURE 8
DRAINAGE
HOLE
DRAINAGE
CHANNEL
When not in use
If leaving the chiller unused for a prolonged period, unplug from mains, wipe dry and leave the doors
open.
