Coolster ATV-3125 Series, Owner'S Manual

Page: 17 / 32

P30 P31
1, the measurement of oil (See left picture)
A. Engine preheater minutes.
B. When the engine stopped operating, hold on a few minutes
later, the oil Cypriots will be removed after the oil-observation.
C. The oil should be located at the highest and the lowest
among the oil-marker. If the oil level low, should be enough oil
to rise to the oil-appropriate.
2, oil and oil filter replacement of the replacement. ( See right
picture)
A. Engine preheater minutes.
B. engine will stop. In an engine oil was placed underneath.
C. discard release oil bolts, release oil. Put oil may moderate
shaking body to be inside the engine from impurities.
Oil
D. installed release oil bolts, and then full of engine oil.
Tightening oil Cypriots.
I. Starting engine and a few minutes to preheat. Preheat should
check whether there are oil spills. If it appears that an oil spill,
should immediately stop engine and check reasons.
3, the replacement of oil in the second about a month or so to
clean oil filters
Warning:
● Do not join any chemical additives. Also lubricating oil clutch,
clutch slipping and additives will.
Note: In the replacement of oil, must be in accordance with the
following method to check oil pressure.
1, removed the cylinder covered with oil release bolts.
2, starter motors, and keep them idle until the oil outflow from
caving hole. If no one minute after the oil outflow or unusual
phenomenon, should stop the engine running to the nearest
COOLSTER dealer or repair shop for repair.
3, after the test should be tightened release oil bolts.
Carburetor adjustment
Carburetor is a key part of the car, the need for fine adjustment.
Most adjustments should be entrusted with the expertise and
experience COOLSTER dealers or repair shops.
Standard Idle:
1500 ± 150 to / min
1. Connect speed
2. Speed Festival through idle screw on the carburetor, idling
provisions set to rotate within the raise into the engine speed, to
a decrease in engine speed from
Idle adjustment
Release oil point
Screw ialing