EN-3
3.
Adjust the date and time or click “Sync with PC” to set with your PC clock.
4.
Click “OK” to save the settings.
5.
After you complete the setting, disconnect the camera from your PC immediately to make the date
and time set correctly.
4.4 Sealing Your Camera
The Waterproof Housing lets the camera perform up to 3 meters or 10 feet under
water. You must seal the camera with Back Cover in order to protect the camera
when using it in wet or moist conditions.
To secure the Back Cover
1.
Attach the Back Cover to the back of the camera and rotate clockwise
until the two black dots are aligned
2.
Slide the latch on the Back Cover to lock it.
To open the back cover, slide the latch on the back cover to loosen it. Rotate the
cover counterclockwise until the white and black dots are aligned.
Notes
1.
Failure to properly seal your camera can result in leaks that
damage or destroy your camera. Your warranty does not cover
water damage resulting from user damage.
2.
The rubber seal on the Cover forms the waterproof barrier to
protect the camera in wet and underwater conditions. You must
keep this seal clean as a single strain of hair or grain of sand
cause leakage into the product.
3.
After every use in salt water, you MUST rinse the outside of the product and the seal with non-salt
water and dry. Not doing this can cause corrosion in the product or failure in the seal, in turn,
damaging the product.
4.5 Power On & Power Off
To power ON the camera:
Press and hold
button. The camera will vibrate and the Green LED will turn on.
To power OFF the camera:
Press and hold
button. The camera will vibrate two seconds and the Green LED will turn off.
4.6 Recording Video
Before starting to record, select the video resolution, 720p30 (1280x720) or WVGA (848x480), by
switching the Video Resolution Switch in the back of the camera.
There are two methods available for starting the video record function. When starting a video recording, a
short vibration indicates recording has started. The LED indicator illuminates RED throughout recording.
1.
Whether the camera power is ON or OFF, simply slide
switch towards the camera front to
start recording , the LED indicator will illuminate RED
2.
When your camera is OFF and
switch is at REC location, press and hold the
button
to turn the camera ON and it will start recording.
Slide
switch backward to stop recording . The camera will vibrate and the LED indicator will
illuminate GREEN to indicate the recording has stopped. The camera will then enter Standby mode.
An additional option is to hold
button to stop the recording and turn the camera off. The camera will
vibrate two seconds and the Red LED light will turn off.
Notes
1.
Video resolution cannot be changed during video recording.
2.
There will be around 2-3 seconds delay before the camera starts recording.
3.
Ensure there is sufficient memory available on the MicroSD card. If the card is full, the camera will
vibrate for five seconds and the Green LED will flash continuously.
4.7 Taking Photos
1.
Turn on the camera by pressing
button.
2.
After the camera power has been turned on, press
button to take a photo. A short vibration
and a flash of the Green LED indicate the action was successful.
Notes
Summary of Contents for S3000
Page 1: ...S3000 User Manual ...
