Cool Compact 1200, Instruction Manual

Page: 19 / 60

18
For cleaning
Before cleaning, switch off the appliance and pull the mains plug.
Remove food from the appliance and store in a suitable place.
Wear suitable gloves (eg nitrile rubber) during cleaning work to prevent skin
irritation.
Choose cleansing products with a sufficient cleansing effect in the case of protein
and fats.
Remove racks.
Check that the hole in the drainage channel is free from contamination.
Clean the corpus, inside surfaces and gaskets with a microfiber cloth that is
repeatedly washed out in the cleaning liquor.
Areas that come directly into contact with food, wipe with clear water.
All surfaces are allowed to dry.
When using surface disinfectants, the respective exposure time must be observed.
The exposure time must not be interrupted by prematurely wiping or rubbing the
surfaces dry.
Turn the appliance on again and place it again after reaching the desired
temperature.
With opened machine compartment cover:
Picture 2
Panel of the installation compartment can be
opened by loosening the fastening screw.
The wiring diagram is located at the left side
behind the installation compartment panel.
Picture 3
Condenser (liquefier)
Ribs can be easily cleaned with opened installation
compartment panel. See chapter 6 „Cleaning and care“
You will find the nameplate on the right side
19
7. DOOR STOP CHANGE FROM RIGHT TO LEFT
Open door 90 . Unscrew the screws at the
bottom of the bezel.
Fold the cover upwards and secure against
falling.
Secure the door against falling.
Remove the screws on the upper right hinge.
Remove the door.
Remove the screws on the right lower hinge.
Remove the hinge.
Hinged on the bottom left.
Turn the door 180 and insert. Secure door and
install the hinge at the top left.