COOL BOSS CB-20SL, Installation And Operation Manual, Page: 13 / 36

Cool Boss Evaporative Air Cooler
13
P/N 5900275 — January 2022 — Rev. A
Setup
There are six basic steps in the Cool Boss set-up.
1.
Unbox.
2. Install the Casters.
3. Install the Media and Back Screen.
4. Determine the Cool Boss location.
5. Fill the reservoir or connect to water supply.
6. Connect to power.
Tools required for Assembly:
• Hammer
• Pry Bar
• Phillips Screwdrivers
• Metric Open End Wrench Set
Unboxing the Cool Boss
The Cool Boss Cooler is carefully packaged to prevent damage. Exercise care in removing the Cooler
from its packaging. Be careful not to injure yourself on sharp edges or fasteners.
⚠
WARNING You must wear the proper protective equipment at all times during setup and
assembly of this Cooler: leather gloves, steel-toed boots, and back belts.
To unbox the Cooler :
Use a hammer and pry bar to
carefully
remove the shipping container from around the Cool
Boss.
Position the Cooler with its Media and Backscreen (intake) side down to provide access to the
bottom of the unit. The back of the shipping container may be used to provide a clear, clean area
to work on the Cooler. See figure below.