ISSUE-1 9/11/2017
5
3.
Ensure all ingredients are close to room temperature. Never use
hot ingredients as this can cause the glass jug to shatter.
4.
Place the ingredients into the glass jug and check that the level is
not above the maximum level marked (1500ml).
5.
Fit the lid, secure the stopper and place the jug onto the motor
housing.
6.
Using the speed control knob, select the appropriate blender
speed for your ingredients. A slower mix will be obtained by
selecting the lowest speed setting (1) and a faster mix by
selecting the higher setting(2).
7.
Mix for a maximum of 3 minutes. If further mixing is required,
wait until the blender has cooled to room temperature before
restarting.
8.
Switch off; allow the blade to stop spinning before checking the
consistency of the mix. If satisfactory, remove the jug.
9.
To use blender on pulse, turn and hold the speed switch to the ‘P’
position for short intervals. The blender will operate at full speed,
when the desired mix is achieved, release the switch.
10.
To stop or interrupt the blending process switch the appliance off
by turning the speed control knob to OFF(0) or by turning off at
the mains.
Notes:
Do not run the blender with the container empty or with solids
only.
Do not use without the seal fitted.
For some types of mixes it may be necessary to fill above the
minimum (250ml) to obtain the most efficient mixing.
The stopper is graduated and may be used as a measuring cup.
CLEANING
Clean the blender after each use.
1.
Switch off and unplug.
2.
The jug, lid and stopper may be washed in hot water with a little
washing up liquid taking care not to handle the blades. Rinse and
wipe dry. Not suitable for dishwashers.
3.
To separate the blade assembly from the glass jug, firmly grasp
the base assembly on the underside of the jug and twist the
Summary of Contents for BL9295G-GS
Page 8: ...ISSUE 1 9 11 2017 8...
