10 ∙ assembling blades and inserts
ASSEMBLING BLADES AND INSERTS
When handling Blades and Inserts, be very careful as their blades are sharp and can
cause injury.
To assemble the Julienne / Slicer Disk, select appropriate Insert
(see Blade Configuration Chart on page 11) and slide into
Julienne / Slicer Disk until the Insert locks into place. Now you
are ready to place the Disk onto the Processing Base.
To remove the Insert, carefully lift Blade Insert up and slide it off
of the Disk. For extra thick slices, do not use an insert.
No assembly required. Simply place on Processing Base and
put the Lid on top.
Slide Cube Insert into Disk by lining up the sides of the Cube
Insert with the slots under the Disk. The arrows on the Cube
Insert should be pointing outward (away from the Blade Disk).
TIP: If you are having difficult assembling the Cube Insert, turn
the Disk and Insert over so that the blade is facing away from
you as it may be easier to see the slots on the underside of the
Disk.
To disassemble, slide Cube Insert outwards.
Julienne / Slicer Disk
Shredder Disk
Cube / Large Cube / Wavy Disk
