Manual CC 5455 IR
21
- Use the 4 directional buttons to move to a character, and select it by pressing the Set button.
Repeat this action to enter multiple characters. Up to 15 alphanumeric characters can be used.
Note
If the cursor is moved to CLR and Set button is pressed, all letters are deleted. To edit a letter,
change the cursor to the bottom left arrow and press the Set button. Move the cursor over the
letter to be edited, move the cursor to the letter to be inserted and then press the Set button.
- Enter a title, move the cursor to 'POS' and press the SET button. The entered title appears on
the screen. Select the position to display the title on the screen using the 4 directional buttons
and press the SET button. When the position is determined, select 'END' and press the SET
button to return to the SPECIAL menu.
o
Sync: In areas where the supply is 60Hz, multiple cameras using the power synchronisation
function (Line-Lock), without using a synchronisation signal generator.
- INT: Internal Synchronisation Type
- L/L: Power Synchronisation Type, Line-lock
* Press the Set button
* Select a phase between 0 and 359
Note
When using AC power at a 60Hz frequency Line-Lock synchronisation can be used.
When the power is DC 12V, the Sync menu is fixed to the INT mode.
o
Motion Det: This camera displays an on-screen message whenever motion is detected.
- When the Special menu screen is displayed, press the Up and Down buttons so that cursor
points to Motion Det.
- Set up function using the 4 directional buttons.
* Sensitivity: Select up to eight MD areas. When the SENSITIVITY value is high, motion
detection sensitivity is increased to recognise small movements.
* Area Mode: Determines whether to use the MD area selected in SENSITIVITY.
* SEL POS: Determines which of the 4 vertices of each MD area is to be used.
* YPOS: Determines the co-ordinates of the vertical axis for SEL POS.
* XPOS: Determines the co-ordinates of the horizontal axis for SEL POS.
* FILL
Æ
SET: Fills in a selected MD area. Fills in a selected MD area. The color of filling is
sequentially selected as brown, orange, blue, cyan, yellowish green, yellow and red.
* Return: Select this to save the MOTION DET menu settings and return to the SPECIAL
menu.
Note
MD area show only on the Motion Det menu. Therefore, MD areas are not displayed on the monitor
screen.