MV3DB Series DB Units
4. Installation
(07/06)
ALSPA MV3000e Dynamic Braking Units
Page 4-1
4. Installation
4.1 Introduction
This section provides comprehensive procedures for installing MV3DB Series DB Units into
ALSPA MV3000e MicroCubicle™- style drives.
4.2 Receipt
of
Equipment
4.2.1 Inspection
Check the contents of the consignment against the Delivery Note for any damage, shortages
or loss in transit. If any item is found to be damaged or missing, contact
Converteam
at the
address/telephone number shown on the rear cover, quoting the following details:
•
List of damaged or missing items with names and part numbers.
•
Description of damage.
•
Delivery Note numbers and dates, and order and item numbers.
4.2.2 Storage
If the DB Unit is not to be installed immediately:
•
Re-pack it in its original packaging material. If this is not possible it should be enclosed in
polythene sheet to protect it from the ingress of dust.
•
Store it in a clean, dry atmosphere, preferably at room temperature, ensuring that the
storage environment meets the requirements of Section 2.
•
If the DB Unit is unpacked in a warm environment condensation may occur.
Should condensation be seen, the DB Unit should not be used until its temperature has
stabilised to that of the working environment.
4.2.3 Handling
CAUTION
This equipment contains solid state devices which may be affected by electrostatic
discharge. Observe static handling precautions.
Because DB Units contain static-sensitive devices, they should be handled carefully without
touching components or connectors, and should preferably be kept in the supplied conductive
bag until required for use.
Take care to protect exposed printed circuit board components from physical damage.
