•
CuePlay
•
Loop Record
•
Prebuffer
•
Timelapse
•
Crank
•
E to E direct
Setting up for 3D playback
•
If playing back footage that was recorded with “Record Combined” turned on, make
sure that “Combine” is turned off, then set the “Play Ref” to “Int”, then simply press play
on the master unit and the video will play out of the SDI-out from the master unit.
•
If playing back footage that was recorded with “Record Combined” turned off, perform
the following steps:
•
Connect the HDMI output from the slave unit to the HDMI input of the master
unit, just as you would for a 3D record.
•
Connect the remote tally to both units
•
Set the “Play Ref” to “Ext” on the master unit only. The slave unit should be set
to “Play Ref” “Int”
•
Set the trigger to “Remote Play” (System->Trigger->Remote Play) on both units.
•
To playback the full resolution video out of the two units to be combined by an
external device, make sure “Combine” is off (Video → 3D → Combing off), then
press the remote trigger button to begin synced playback. The 'right-eye' will
play out of the slave unit SDI-out and the 'left-eye' video will play out of the
master unit SDI-out.
•
To playback the footage as combined video, set “Combine” to the desired
combining method and then press the remote trigger button. The video will play
combined out of the master unit SDI out.
•
During playback, pausing and fast forward is not functional due to the need to
keep the units frame synchronized.
•
To stop playback, double click the remote
Note: Play PSF to Prog under the video menu can be used to convert recorded
progressive formats to interlaced playback to support monitors that do not support
progressive video. This setting needs to match between the units and can not be used
with 1080p24 material due to HDMI not supporting 1080psf24.
3D Menu Options (Video → 3D)
Enable [ ]
To enable 3D recording, check this box. If this is turned off (unchecked), the two units
operate as two separate nanoFlash recorders.