Duration HH:MM:SS
If enabled, each record session will last
only for the specified
HH:MM:SS.
(ver1.5.31)
Timecode
Sets the time-code source, and (for internally generated timecode only) the drop-frame flag
and the initial value (seed)
Source (Embedded, Internal, LTC)
1.
Embedded
– timecode is extracted from HD/SD-SDI stream from the source
2.
Internal
– timecode is generated internally in the nanoFlash
3.
LTC
– timecode from external LTC input
4.
Jam Sync –
provide momentary timecode jam sync (via the LTC input port)
while unit is in idle mode with a valid input source. If video source is lost,
timecode must be re-sync'ed after video source returns.
Dropframe
– [ ] enable (checked) if drop-frame time-code should be generated (only
valid for internal time-code generation and 59.94/29.97 frame rates)
Seed
– initial value for
internal
time-code
only
:
1.
Set 01:00:05:19 –
Allows you to manually set the initial time code. Use the left
and right arrows to navigate to the various settings (HH:MM:SS:FF) and then use
the up and down arrows to increase / decrease the values.
2.
Time of day
– Use time of day time code, based on the System->Time setting.
3.
Reset
– set the initial time-code to 00:00:00:00.
Source:
Selects the video input source – choose between SDI and HDMI.
Format:
Format (erase) all inserted CF cards. The 1
st
7 characters of the CF card Volume
name are preserved. If the last 4 characters of the Volume are digits, they will be incremented
automatically (to help indicate card usage). (ver1.5.31)
Power Saving
Auto Sleep (temporarily disabled due to occasional difficulty waking up
properly)
(1.6.29)
If this feature is turned on, the nanoFlash will drop to low power mode after 1 minute of
inactivity if no SDI input is present. (This feature does not apply for HDMI input.)
When the unit is in low power mode, power consumption drops to 0.3 watts, and the lcd
screen is active with “Low power mode” message displayed.
In low power mode, any of the following events will bring the unit back to full power:
> SDI input resumes.
> Any of the keys on the keypad are pressed.
> A remote tally, if attached, is pressed.
Auto LCD Off
This turns off the LCD backlight after 15 seconds of inactivity. The LCD backlight
consumes about 0.2 watts of power, so this provides slight power saving.
Create Settings.txt:
Primarily a tech support diagnostic tool, creates a file settings.txt with all
current settings.
Only use this option with a formatted, blank CF card inserted
. (ver1.5.31)
Restore Defaults:
Restores factory default settings.
About:
Displays the current firmware version number.
nanoFlash
13