CONTROLS, INCORPORATED
C O N T R O L S Y S T E M S & S O L U T I O N S
- 19 -
(4)
Engine Safety Configuration
Sender Check Bypass Time (Default = 0:10)
Fuel Level Check Selection (Default = Run)
Low Fuel Level Pre Alarm % Selection (Default = 20%)
Low Fuel Level Alarm % Selection (Default = 1%)
Fuel Level Alarm Delay Time (Default = 0:05)
Oil Pressure Check (Default = Run)
Low Oil Pressure Pre Alarm % (Default = 6 PSI)
Low Oil Pressure Alarm % (Default = 5 PSI)
Oil Pressure Alarm Time Delay (Default = 0:10)
Engine Temperature Check (Default = Off)
Engine Low Temperature Pre Alarm (Default = 0 Degrees F)
Engine Low Temperature Alarm (Default = 0 Degrees F)
Engine High Temperature Pre Alarm (Default = 244 Degrees F)
Engine High Temperature Alarm (Default = 245 Degrees F)
Engine Temperature Alarm Time Delay (Default = 0:10)
Battery Volt Check (Default = Off)
Low Battery Volt Pre Alarm (Default = 12.0 Volts)
High Battery Volt Pre Alarm (Default = 15.0 Volts)
Battery Volt Trim Setting 100mV (Default = 5)
Over speed Alarm (Default = Off)
Over speed Alarm RPM Setting (Default = 3000 RPM)
Over speed Alarm Time Delay Selection
(5)
Module Configuration
English/Metric Selection
Hour Meter Source (Default Engine ECU)
Hour Meter Setting (if not ECU)
Battery Volt Source (Default = J1939)
Pre Alarms Displayed (Default = 4)
Clear Operation Log Yes/No
Clear Alarm Log Yes/No
(6)
CAN Configuration
Source Address (Default = 44)
TSC1 Address (Default = 3)
Engine Address (Default = 0)
Oil/Fuel Transmit
