background image

INTRODUCTION

TechniChlor is a semi-automated, salt water chlorine generation system specifically designed for portable spas up 

to 1000 Gallons.  TechniChlor generates chlorine from a small amount of ordinary salt (Sodium Chloride, NaCl) 

dissolved in the spa water.  The amount of salt added is very small in relation to the volume of the water in the spa.  

It’s about 90% less concentration than ocean water and below the typical taste level of most humans.

  

The small addition of salt also benefits users by providing a softening effect on the water, leaving hair and skin feel

-

ing smoother and healthier than with traditional sanitizing products.  Only 2.5 cups of salt per 100 gallons of water 

is all it takes for TechniChlor to produce fresh, pure chlorine leaving your water clean and clear day after day.

IMPORTANT SAFETY INSTRUCTIONS

READ & FOLLOW ALL INSTRUCTIONS

SAVE THESE INSTRUCTIONS

When installing and using this electrical equipment, basic safety precautions should always be followed, 

including the following:
WARNING

:  

To reduce the risk of injury, do not permit children to use this product unless they are closely  

 

 

 

supervised by at all times.

WARNING

:    Use TechniChlor only according to these instructions.  Any modification or misuse of this product    

 

 

will void the warranty.

WARNING

:  

Install TechniChlor in accordance with all national and local electrical, plumbing, safety, and other   

  applicable 

codes.

WARNING

:  

Connect TechniChlor to a GFCI (ground fault circuit interrupt) or GFI (ground fault interrupt)

 

 

protected VAC power source only.

WARNING

:  

Protect the power supply and outlet from exposure to the elements including direct sun, rain, snow,  

  condensation, 

etc.

WARNING

:  

DO NOT use with extension cord.  Injury may result.

WARNING

DO NOT insert objects into, or tamper with TechniChlor’s body in any way.  Inserting metal objects  

 

 

into the body may cause damage and void the warranty.

WARNING

DO NOT operate TechniChlor if damaged in any way.

WARNING

:  

DO NOT pull on the cord to disconnect the Power Supply from power source.  Do not allow the    

 

 

cord to rest on sharp edges or corners or to be walked upon.  Do not drop, throw, or otherwise    

  rough 

handle 

TechniChlor.

WARNING

DO NOT handle the unit during chlorine production (visible bubbling).  Slight discomfort may be felt  

 

 

in cuts, sores, or sensitive skin areas due to chlorine concentration and the electrolysis process.    

 

 

Stop chlorine production by either removing TechniChlor from the water by lifting the cord (do  

 

 

 

not grasp the housing), or by unplugging the power supply from the power source.

WARNING

:    Unit must be disconnected from power source before performing any maintenance or 

  troubleshooting 

operations.

WARNING

Disconnect, remove, and store or TechniChlor indoors when spa has been winterized or drained.

CAUTION

Leave spa cover open at least 30 seconds to allow trapped gases to escape prior to use.

CAUTION

If unit is not working properly, or has been damaged in any way, contact technical support

 

 

immediately at 1-530-205-4520.

CAUTION

Measure water quality parameters and adjust if necessary prior to each spa use.

CAUTION

Make sure all spa electrical components and power cords have been thoroughly inspected by a

 

 

licensed electrician prior to using TechniChlor.

Summary of Contents for TechniChlor













Reviews: