background image

LIMITED WARRANTY

Models: 

This warranty applies to TechniChlor models referenced as “System”.

ControlOMatic, Inc. Warrants the system to be free of all defects in material and workmanship for one (1) year from 

the original purchase date. The system includes the power supply unit, cable, electronics, and electrolytic genera-

tor for residential use only.  The product must be installed properly and used in accordance with this manual and all 

applicable local codes and regulations. This warranty is not transferable. 
In no event shall ControlOMatic, Inc. be liable for consequential damages for breach of this warranty. Some states 

do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion 

may not apply. The warranty does not cover any loss or damage to the product due to improper installation, product 

abuse, misuse, negligence, or improper maintenance of the system, pool or spa.  The warranty does not cover any 

loss or damage to the spa, spa components, users, or anything outside the system due to system failure.  Purchas

-

er assume all responsibility for using the system.
This warranty does not apply to any costs, repairs, services, damages, claims or losses for all of the following: Ser

-

vice calls to install, re-install or correct the installation of the product, or to explain the usage of the system to the 

buyer, repairs necessitated by use other than normal home use, damage resulting from misuse, unintended use, 

unforeseen use, non pool or spa use, abuse, accidents, alterations, improper installation, or corrective work neces

-

sitated by repairs made by anyone other than an authorized service technician.

THE FOREGOING WARRANTIES ARE CONTINGENT ON THE PROPER USE OF THE SYSTEM IN ACCOR-

DANCE WITH THESE INSTRUCTIONS AND SPECIFICATIONS AND SHALL NOT APPLY TO ANY SYSTEM 

THAT HAS BEEN REPAIRED OR MODIFIED BY PERSONS OTHER THAN THE MANUFACTURER.
THE EXPRESS WARRANTIES SET FORTH IN THIS AGREEMENT ARE IN LIEU OF ALL OTHER WARRAN-

TIES, EXPRESS OR IMPLIED. MANUFACTURER HEREBY SPECIFICALLY DISCLAIMS ANY OTHER REPRE-

SENTATIONS OR WARRANTIES, EXPRESS OR IMPLIED, INCLUDING WITHOUT LIMITATION ANY WARRAN-

TIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
IN NO EVENT WILL MANUFACTURER’S LIABILITY FOR ANY CLAIM, WHETHER IN CONTRACT, TORT OR 

UNDER ANY OTHER THEORY OF LIABILITY, EXCEED THE AMOUNT NECESSARY TO REPAIR OR RE-

PLACE THE COVERED SYSTEM.

Damage to the system from improper water maintenance is not covered in this warranty. 

Should any problem develop during the warranty period, go to: www.controlomatic.com to obtain the proper techni-

cal support phone number. You will need the serial number visible in the clear part of the system body. You may be 

required to return the defective component, and if necessary, the component will either be repaired or replaced.

Summary of Contents for TechniChlor













Reviews: