Press CODE SET
button five times
Select one of the
four buttons (not
programmed yet ) you
wish to use to control
the door for pet position
Fig. 34
Fig. 35
Fig. 36
Coding Transmitters
Step 17.5 - Setting the Transmitter to Operate Pet
(Pedestrian) Mode
The opener can be programmed into a “Pet Mode” where the
door opens partially to allow pets to enter/exit the garage:
Press the
a.
CODE SET button five times, the CODE SET
LED will illuminate and the courtesy light will flash
quickly (twice per second) to indicate learning mode for
Pet Mode is active.
Choose a transmitter button not already coded into the
b.
receiver. Press this button and the CODE SET LED will
begin to flash.
Press the same transmitter button again. The CODE
c.
SET LED will illuminate for one second and then go out,
and the courtesy light will also switch off. This indicates
the code has been stored. This indicates the code has
been stored
(Fig. 34)
.
Step 17.6 - To erase Programmed Codes
If the CODE SET button is pressed and held for 6 seconds the
CODE SET LED will blink rapidly for one second to indicate
that all programmed codes have been erased.
(Fig. 35)
Step 17.7 - Installation of the Wall Mounted
Transmitter
Mount the transmitter in a convenient location, yet out
a.
of reach of children and at least 1.5m off the ground
(Fig. 36)
.
Make sure the door is visible from this location.
b.
To set the transmitter codes refer to Step 17.1.
c.
Controll-A-Door
®
P
Diamond
Instruction Manual
20
