Control Microsystems SCADAPack Micro 16, Quick Start Manual

Page: 6 / 12

SCADAPack Micro 16 Quick Start Guide
October 19, 2007 5
3 Quick-Start Procedure
3.1 Connect Input Power
Connect the 16Vrms or 24V wiring to the AC/DC PWR IN terminals on the 5203/5204 board. Do
not apply power to the controller at this time.
3.2 Power Up In Cold Boot Mode

This procedure initializes the serial communication parameters and the I/O database registers to
their default values, erases the Register Assignment, Ladder Logic and C programs, and unlocks
the controller.

Hold down the LED POWER button.

Apply power to the Micro 16 controller.

Continue holding the LED POWER button for 25 seconds until the STAT LED begins to flash
on and off continuously.

Release the LED POWER button.
3.3 Connect Computer to TeleSAFE Micro 16
Connect a null modem cable from the computer serial port to com2 on the TeleSAFE Micro 16
controller board.
LED Power
Button
AC/DC PWR IN
Terminals