ZigBee Extender 3
Features
The Card Access ZigBee Extender 3 operates as a ZigBee® (IEEE 802.15.4) router and mesh extender. The Extender
is designed to improve ZigBee signal latency that can occur when ZigBee devices are installed on the fringes of a
ZigBee mesh network. The Extender is also used to extend the ZigBee network into distant or hard-to-reach areas.
The ZigBee Extender 3 works with your Control4® system and should be located within 500 feet of another routing
node. For optimal results, the Extender should be located in areas of the project where the mesh may be weak or
non-existent. The Extender should not be placed next to a Home Controller.
Supported Models and Requirements
This documentation applies to the following Card Access products:
ZXT30 ZigBee Extender 3
Requires a Control4 Home Controller with Composer 2.0 or higher.
Important Safety Instructions
WARNING! You should install this device in accordance with all national and local electrical codes.
IMPORTANT! This product is not intended for direct connections to AC mains (120V/220V). Refer to specifications.
IMPORTANT! Improper use or installation of this device can result in LOSS OF/DAMAGE TO PROPERTY.
IMPORTANT! Using this product in any manner other than outlined in this document voids your warranty. Also,
Card Access is NOT responsible or otherwise liable in any way for any damage resulting from the misuse of this
product. See the section of this document entitled WARRANTY for details.
What Is Included:
One (1) ZigBee Extender 3 device
One (1) North American 5V DC power supply
One (1) wall mounting Velcro strip
One (1) Button Press Guide/LED Color Code instruction card
Specifications
Power Source: 5VDC Power Supply
Power Usage: 65 mA at 5V
Device Temperature Range: Operational -20°F to 158°F (-28°C to 70°C)
Humidity 5% to 95% Non-Condensing
Storage -20°F to 158°F (-28°C to 70°C)
Dimensions (LxWxD): 2.80”(L) x 1.75”(W) x 0.57(D)” (77.1mm x 44.5mm x 14.4mm)
