PAGE 16
7.
NOTE:
The Generator features a 10 AMP DC Fuse (9) to protect the DC circuit in
case of an overload. Should an overload occur the Fuse will burn out. In this
case, refer to Step #1 in this section. Then, reset the circuitry system by replacing
the burnt Fuse with a new 10 AMP DC Fuse. Restart the Generator and continue
powering the remaining tool or equipment.
(See Figure H.)
4.
Start and run the Engine as previously discussed in this manual.
5.
When finished using the Generator, turn the Engine Power Switch (2) to its
“OFF”
position. Turn the Fuel Valve (40) to its
“OFF”
position. Then, disconnect
the electrical powered tools' power cord from the Generator's DC Terminals (7).
(See Figure H.)
6.
After the Engine and Generator have completely cooled, store the Generator in a
safe, clean, dry location (if not already installed in one).
3.
If using
only
a 12 volt DC tool or equipment turn both the 120v and 240v breakers
to their
"OFF"
position.
(See Figure D.)
Summary of Contents for GEN03213
Page 1: ...8000W GENERATOR 8000W GENERATOR Stock No GEN8000 03213 Instruction Manual...
Page 19: ...PAGE 19...
Page 21: ...ASSEMBLY DIAGRAM A PAGE 21...
Page 22: ...WIRING DIAGRAM PAGE 22...
