Continental Fireplaces CWHD31N, Installation And Operating Instructions Manual

Page: 20 / 96

20
W415-1338 / 07.09.14
EN
4.3 USING FLEXIBLE VENT COMPONENTS
For safe and proper operation of the appliance, follow the venting
instructions exactly.
All inner
fl ex pipe and outer fl ex pipe joints may be sealed using high
temperature sealant W573-0002 (not supplied) or the high temperature
sealant W573-0007 Mill Pac (not supplied). However, the high temperature
sealant W573-0007 Mill Pac (not supplied) must be used on the joint
connecting the inner
fl ex pipe and the exhaust fl ue collar.
Use only approved fl exible vent pipe kits marked:
“Wolf Steel Approved Venting” as identifi ed
by the stamp only on the outer fl ex pipe.
22.1
ELBOW
SPACERS
DO NOT ALLOW THE INNER FLEX PIPE TO BUNCH UP ON HORIZONTAL OR VERTICAL RUNS AND ELBOWS.
KEEP IT PULLED TIGHT.
SPACERS ARE ATTACHED TO THE INNER FLEX PIPE AT PREDETERMINED INTERVALS TO MAINTAIN AN EVEN
AIR GAP TO THE OUTER FLEX PIPE. THIS GAP IS REQUIRED FOR SAFE OPERATION. A SPACER IS REQUIRED
AT THE START, MIDDLE AND END OF EACH ELBOW TO ENSURE THIS GAP IS MAINTAINED. THESE SPACERS
MUST NOT BE REMOVED.
!
WARNING
A.
Install the inner fl ex pipe to the fi replace. Secure with
3 screws and fl at washers. Seal the joint and screw
holes using the high temperature sealant W573-0007
(not supplied).
B.
Install the outer fl ex pipe to the fi replace. Attach and
seal the joints using the high temperature sealant
W573-0002 (not supplied).
28.4A
HIGH
TEMPERATURE
SEALANT
SCREWS
1 1/2” OVERLAP
(38.1mm)
4.3.1 APPLIANCE VENT CONNECTION