English
- 42 -
Channel list
Use of the channel list
You can configure the channel list by moving, deleting,
renaming and locking them to your liking.
Setting of parental control settings
To prevent certain programs from being watched, channels
and menus can be locked through the parental control system.
To display lock menu option, enter the PIN code. By
default, the set factory code is
0000
. After entering the
appropriate PIN code, the Parental control settings
menu will be displayed :
Menu lock
: The Menu lock option enables or disables
access to the menu.
Maturity lock:
After installation, this option searches
information related to parental programs and if this
parental level has been disabled, access to broadcast
is not enabled.
Parental control lock
: When the Parental lock option
is selected, the television can only be controlled with a
remote control. In this case, the control panel buttons
will not be active.
PIN code setting
: Defines a new PIN code.
The default PIN code can change depending on
the country selected.
If a PIN code is required to display a menu option,
enter one of the following codes:
0000
or
1234
.
Electronic Program Guide (EPG)
Some channels, not all, display information concerning
the on-going program and the next one. Press the
button to get access to the EPG menu.
Up/Down/Left/Right:
Navigate EPG.
OK:
Displays programme options.
INFO:
Displays, in detailed, information on the
programme selected.
GREEN:
Switches to List Schedule EPG.
YELLOW:
Switches to Timeline Schedule EPG.
BLUE:
Displays filtering options.
Programme Options
In
EPG
menu, press the
OK
button to enter the
Event Options
menu.
Select Channel
In
EPG
menu, using this option, you can switch
to the selected channel.
Set Timer / Delete Timer
After you have selected a programme in the
EPG
menu, press the
OK
button. Select the
Set Timer on
Event
option and press the
OK
button. You can set
a timer for future programmes. To cancel an already
set timer, highlight that programme and press the
OK
button. Then select “
Delete Timer
” option. The
timer will be cancelled.
(
RECORDING
):
The television starts to record
the selected program. You can press again to stop
recording.
P+P-:
More info on the events
IMPORTANT
: Connect your USB device only when your
television is turned off. Then turn on the TV set in order to
enable the record function.
Note
: During recording,it is not possible to change the
channel or Source.
Note
: It is impossible to record two channels at the same time.
Connectivity Functions
Connecting to a Wired Network
• Connect broadband ISP connection ethernet cable
to the ETHERNET INPUT of your modem.
• Ensure that Nero Media Home software is installed
to your PC.(for DLNA function). See Appendix A.
• Connect your PC to the one of your modem’s LAN
connectors (e.g. LAN 1) by using a proper LAN cable.
• Use another LAN output of your modem (e.g. LAN
2) to enable the connection to your TV.
Lan(Ethernet cable)
Broadband ISP
Connection
Rear of TV
• To access and play shared files, you must Select
Media Browser. Press Menu button and select Media
Browser. Press OK to continue. Select the desired
file type and press OK. You must always use the
Media Browser screen to access and play shared
network files.
• PC/HDD/Media Player or any other devices that are
DLNA 1.5 compatible should be used with wired
connection for higher playback quality.
To configure wired settings please refer Network
Settings section in Settings menu.
• You might be able to connect your TV to your LAN
network depending on your network’s configuration.
In such a case, use an ethernet cable to connect
your TV directly to the network wall outlet.
