Edition 05/2014 - X-ONE - page 7
SACOME, CONFIDENTIAL Document,
it is forbidden to duplicate or communicate this document without previous authorization.
5
OPERATION
5.1 RECOMMANDATIONS
Open the general water tap, if it is closed, then open the water shutoff valve dedicated to the
machine.
Do not put the supplying voltage at this moment.
Verify the presence of water, by reading the pressure of the mains water inlet on the M2 manometer
pump.
5.2 INITIAL FILLING
Ensure that steam taps operating levers ‘V’ are open (up).
Put the ON/OFF switch ‘C’ to position 1 (power on).
Bar led under the key board turn to on.
The boiler fills automatically, without heating.
The machine start to heat automatically, only when the level probe is reached by the water
A scrolling LED on keypads can inform the user about the status (display shows: "boiler heating")
Close the steam tap “V” and wait.
When the scrolling leds stops : The machine is ready to operate (display shows: « Hour + T° + X-
ONE »)
5.3
FURTHER FILLINGS
Further fillings will run automatically, according to the hot water needs.
The water level in the boiler is controlled by the electronics, by the means of a level probe.
