PILOT-192PRO
- 192-channel DMX controller with joystick and USB port
Page 7
English
6 - Manual control
The default program is the manual/black-out mode. All outputs are in black-out mode. The console is
in manual mode if the black-out light indicator of the display is not flashing. Press the
BLACK-OUT
button
to switch from black-out mode to manual mode, then select a projector by pressing the corresponding
PROJECTORS
button and use the 8 faders, the joystick and the
PAGE SELECT
button to control your projectors.
NB :
You will need, in most cases, to assign the joystick to be able to control your projectors (please refer to
page 5 for more information about this).
7 - Programming a scene
1 -
Press and hold the
PROGRAM
button for 2 seconds, until the
Prog
indicator flashes to indicate the Prog
mode has been activated.
2 -
Use the
PROJECTORS
buttons to indicate which projectors will be used for this scene. The LEDs of the
selected projectors will light on.
3 -
Use the
faders
,
joystick
and
PAGE SELECT
button to create your scene. The
PAGE SELECT
button must be
used to navigate between channels 1 to 8 and 9 to 16.
4 -
Use the
BANK
or
buttons and select a bank of scenes. There are 30 banks available, each of them is
designated by two digits on the display (at the right)
.
6 -
Press the
MIDI/REC
button and the scene button corresponding to the scene you want to save. All the LEDs
will flash 3 times to confirm your choice.
Each bank has 8
SCENES
buttons, please make sure to save each scene via a different button in order not to
erase scenes you want to preserve.
7 -
Repeat steps 1 to 6 to program more scenes.
8 -
Once all your scenes have been programmed, press the
PROGRAM
button for 2 seconds to leave the
Program mode. The
Black-out
indicator will flash to confirm you have left the Program mode.
