6 BIOS Setup
SIS-8601-LVA
71
PLEASE RUN EISA CONFIGURATION UTILITY
The non-volatile memory containing EISA configuration information was programmed
incorrectly or has become corrupt. Re-run EISA configuration utility to correctly program the
memory.
NOTE: When this error appears, the system will boot in ISA mode, which
allows you to run the EISA Configuration Utility.
Keyboard error or no keyboard present
Cannot initialize the keyboard. Make sure the keyboard is attached correctly and no keys are
being pressed during the boot.
If you are purposely configuring the system without a keyboard, set the error halt condition in
Setup to HALT ON ALL, BUT KEYBOARD. This will cause the BIOS to ignore the missing
keyboard and continue the boot.
Memory address error at ...
Indicates a memory address error at a specific location. You can use this location along with the
memory map for your system to find and replace the bad memory chips.
Memory parity error at ...
Indicates a memory parity error at a specific location. You can use this location along with the
memory map for your system to find and replace the bad memory chips.
Memory size has changed since last BOOT
Memory has been added or removed since the last boot. In EISA mode use Configuration Utility
to reconfigure the memory configuration. In ISA mode enter Setup and enter the new memory
size in the memory fields.
Memory verify error at ...
Indicates an error verifying a value already written to memory. Use the location along with your
system's memory map to locate the bad chip.
Offending address not found
This message is used in conjunction with the I/O CHANNEL CHECK and RAM PARITY
ERROR messages when the segment that has caused the problem cannot be isolated.
Summary of Contents for SIS-8601-LVA
Page 15: ...1 Introduction 8 SIS 8601 LVA...
Page 37: ...3 Jumper Setting 30 SIS 8601 LVA...
Page 41: ...4 CPU card Resources 34 SIS 8601 LVA...
Page 89: ...6 BIOS Setup 82 SIS 8601 LVA...
