1. Before Using the Product
DIO-6464T2-PCI, DI-128T2-PCI, DO-128T2-PCI
3
Cable & Connector (Option)
Shielded Cable With Two 100pin Connector
: PCB100PS-0.5 (0.5m)
:
PCB100PS-1.5
(1.5m)
Connection Conversion Shield Cable (100P
→
96P) :
PCB100/96PS-1.5(1.5m)
Flat Cable with One 100-Pin Connector
: PCA100P-1.5(1.5m)
Connection Conversion Shield Cable (100P
→37
P D-SUB x 2)
:
PCB100WS-1.5(1.5m)
*
If using both the CNA and CNB connectors, two cable sets are required.
Accessories (Option)
Screw Terminal (M3 x 100P)
:
EPD-100A *1*4*6
Screw Terminal (M3 x 96P)
:
EPD-96A *2*4*6
Screw Terminal (M3.5 x 96P)
:
EPD-96 *2*4
Screw Terminal (M3 x 96P)
:
DTP-64A *2*4
Connector Conversion Board
:
CCB-96 *2*4
Signal Monitor for Digital I/O (64Bits)
:
CM-64L *2*4
Screw Terminal (M3 x 37P)
:
EPD-37A *3*5*6
Screw Terminal (M3.5 x 37P)
:
EPD-37 *3*5
General Purpose Terminal
:
DTP-3A *3*5
General Purpose Terminal (M3 x 37P)
:
DTP-3C *3
Screw Terminal
: DTP-4A *3*5
Screw Terminal (M2.5 x 37P)
: DTP-4C *3
Signal Monitor for Digital I/O (32Bits)
:
CM-32L *3*5
*1 PCB100PS optional cable is required separately.
*2 PCB100/96PS optional cable is required separately.
*3 PCB100WS optional cable is required separately.
*4 If using both the CNA and CNB connectors, two each of the terminal and cable sets are required.
*5 If using both the CNA and CNB connectors, two cable sets are required.
You will also require sufficient terminal blocks for the number of I/O points you are using.
*6 “Spring-up” type terminal is used to prevent terminal screws from falling off.
*
Check the CONTEC’s Web site for more information on these options.
