Contec DAI16-4(USB), User Manual

Page: 26 / 65

3. Setup
DAI16-4(USB)
19
3.8. Connecting to an External Device
3.8.1. Signal Layout
The Module can be connected to an external device using a 12-pin (1 group) connector that is provided
on the Module face.
Figure 3.5. Signal Layout on the Interface Connector < DAI16-4(USB) >
3.8.2. Connection Method
When connecting the Module to an external device, you can use the supplied connector plug. When
wiring the Module, strip off approximately 9 - 10 mm of the covering for the cable, and insert the bare
wire by pressing the orange button on the connector plug. Releasing the orange button after the wire
is inserted fixes the cable. Compatible wires are AWG 28 - 16.
Removing the connector plug by grasping the cable can break the wire.
Figure 3.6. Connecting an Interface Connector and Connectors That Can Be Used
12
11
10
9
8
7
6
5
4
3
2
1
CH0 [V]
CH0 [C]
AG
CH1 [V]
CH1 [C]
AG
CH2 [V]
CH2 [C]
AG
CH3 [V]
CH3 [C]
AG Analog Output [Voltage output] 0
Analog Output [Current output] 0
Analog Ground
Analog Output [Voltage output] 1
Analog Output [Current output] 1
Analog Ground
Analog Output [Voltage output] 2
Analog Output [Current output] 2
Analog Ground
Analog Output [Voltage output] 3
Analog Output [Current output] 3
Analog Ground
CH0
CH1
CH2
CH3
V
C
AG
V
C
AG
V
C
AG
V
C
AG
Flange
CAUTION
- Applicable connector
3.81mm-pitch, 12-pin type of rated current 8A
MC-1,5/12-GF-3,81 [Made by Phoenix Contact]
- Applicable plug(accessory b undled)
Front-screw type with connector locking flange
FRONT-MC 1,5/12-STF-3,81 [Made by Phoenix Contact]
Applicable cable AWG28-16
9 - 10mm