Contec CONPROSYS Linux SDK, User Manual

Page: 28 / 61

—
Run environment setting
—
CONPROSYS Linux SDK User’s Manual (Self -Build Edition)
— 28 —
2. Network setting
Default network setting is set as follows:
[Default setting]
LAN A (eth0): 10.1.1.101
LAN B (eth1): DHCP
* When executing a kernel generated with 1lan (SINGLE EtherMAC), the setting of LAN B is invalid
(operated by HUB mode).
The network can be set by connecting to CONPROSYS through LAN from Web browser on PC.
For details, refer to “ Web Setup function (page 25) ”.
If you would like to change the network setting by command prompt, edit the file below on the
target with root privileges. The settings can be enabled by rebooting this file.
/etc/conprosys/config.ini
LAN Configuration
Item name Description
eth0_dhcp Set DHCP enabled or disabled of LAN A (eth0).
enabled
disabled
eth0_ipaddr Set IP address of LAN A (eth0).
eth0_netmask Set a netmask of LAN A (eth0).
eth0_gateway Set a gateway address of LAN A (eth0).
eth0_dns1 Set DNS server address of LAN A (eth0).
eth1_dhcp Set DHCP enabled or disabled of LAN B (eth1).
enabled
disabled
eth1_ipaddr Set IP address of LAN B (eth1).
eth1_netmask Set a netmask of LAN B (eth1).
eth1_gateway Set a gateway address of LAN B (eth1).
eth1_dns1 Set DNS server address of LAN B (eth1).
ntp_addr Set NTP server.
host_name Set a host name.
The following name is used as the default host name since there is no item
in the setting.
The model name + the lower 3 bytes of MAC address