2. Setup
COM-1(LPCI)H, COM-2(LPCI)H, COM-4(LPCI)H
11
Step 1 Setting the Hardware
This section describes how to set the board and plug it on your PC.
The board has some switches and jumper to be preset.
Check the on-board switches and jumpers before plugging the board into an expansion slot.
The board can be set up even with the factory defaults untouched. You can change board settings later.
Replacing the Bracket
The board is shipped with the bracket for Low Profile PCI. If you wish to mount the board in a PCI slot,
replace this with the PCI bracket. The diagram below shows how to replace the bracket.
Screw
Bracket for the PCI
Use a flathead screwdriver or hexagonal
spanner to undo and tighten the screws.
Remove the screws and replace the low-profile
PCI bracket with the standard PCI bracket.
Bracket for the Low Profile PCI
Figure 2.1. Replacing the Bracket
