Contec bx200 SERIES, User Manual

Page: 12 / 115

1. Introduction
BX-2x0-DCxxxx, BX-2x0D-DCxxxx User’s manual
5
CAUTION
- Do not use or store this product in a location exposed to high or low temperature that exceeds range
of specification or susceptible to rapid temperature changes.
Example:
- Exposure to direct sun
- In the vicinity of a heat source
- Do not use this product in extremely humid or dusty locations. It is extremely dangerous to use this
product with its interior penetrated by water or any other fluid or conductive dust. If this product
must be used in such an environment, install it on a dust-proof control panel, for example.
- Avoid using or storing this product in locations subject to shock or vibration that exceeds range of
specification.
- Do not use this product in the vicinity of devices that generate strong magnetic force or noise. Such
products will cause this product to malfunction.
- Do not use or store this product in the presence of chemicals.
- To clean this product, wipe it gently with a soft cloth dampened with either water or mild detergent.
Do not use chemicals or a volatile solvent, such as benzene or thinner, to prevent pealing or
discoloration of the paint.
- This product’s case may become hot. To avoid being burned, do not touch that section while this
product is in operation or immediately after turning off the power. Avoid installation in a location
where people may come into contact with that section.
- CONTEC does not provide any guarantee for the integrity of data on CF.
- Always remove the power cable from the power outlet before connecting or disconnecting a
connector.
- To prevent corruption of files, always shutdown the OS before turning off this product.
- CONTEC reserves the right to refuse to service a product modified by the user.
- In the event of failure or abnormality (foul smells or excessive heat generation), unplug the power
cord immediately and contact your retailer.
- To connect with peripherals, use a grounded, shielded cable.
- The CF card connector doesn't support hot plug. The pulling out opening of the CF card cannot be
done in the state of power supply ON. Please neither pulling out opening of CF in the state of power
supply ON of this product nor come in contact with CF. This product may malfunction or cause a
failure.
- If you use any other CFs than our CFs, we can not guarantee this product’s specification. When you
newly select CFs for this product, you should read “Chapter 6. CF selection” at first. If you select
unpreferable CFs, the system may work out of order.
- Component Life:
(1) Battery---The internal calendar clock and CMOS RAM are backed by a Lithium primary battery.
The backup time at a temperature of 25°C with the power disconnected is 10 years or
more.
(2) CF ---The OS-installed model uses a CF card in the OS storage area.
The predicted failure rate is 3,840,000 rewrite operations (allowable number of rewrite
operations of 512KB or less) and MTBF is 500,000 hours.
* Replacement of expendables is handled as a repair (there will be a charge).