Step 10:
Locate the loose wires from the end of the
Microphone cable. Shorten the cable to the desired
length, allowing for 2”
-
3” of excess wire behind the
driver. It is recommended to strip the red wire back
far enough to bend the wire into a tight loop, then
“tin” this wire. Next, strip, then solder the white
wire to the copper wire (If you do not have a
soldering iron handy,
tightly
twist the white wire and
copper wire together). Connect these wires to the
extra two-terminal connector provided with your STS
K020 kit. Secure the wires in the terminals as shown
with the Red wire on the right and the white/copper
wires on the left.
Plug this connector into the “Cust Mic” slots on the
back of the Driver.
Summary of Contents for STS K020
Page 3: ...STS K020 Components ...