24
Your risk from these exposures varies, depending
on how often you do this type of work. To reduce
your exposure to these chemicals: work in a well
ventilated area, and work with approved safety
equipment, such as those dust masks that are
specially designed to filter out microscopic particles.
WARNING:
Do not attempt to operate this tool
until you have read thoroughly and
understand completely all
instructions, safety rules,
etc. contained in this manual.
Failure to comply can result in
accidents involving fire, electric
shock, or serious personal
injury. Save this operator’s manual
and review frequently for
continuing safe operation and
instructing others who may use
this tool.
WARNING:
The operation of any grinding can
result in foreign objects being
thrown into your eyes, which can
result in severe eye damage.
Before beginning power tool
operation, always wear safety
goggles or safety glasses with
side shields and a full-face shield
when needed. We recommend
Wide Vision Safety Mask for use
over eyeglasses or standard
safety glasses with side shields.
ELECTRICAL SAFETY
Always check that the
power
supply corresponds to the
voltage on the rating plate.
DESCRIPTION
1 On/off switch
2 Dry-grinding wheel
3 Wheel guard
4 Spark guard
5 Transparant screen
6 Workpiece support
7 Adjusting screw
8 Mounting hole
9 Wet-grinding wheel
10 Water tank
MOUNTING THE MACHINE
The machine must be screwed to a workbench.
Mark the position of the mounting holes (8)
on the workbench.
Drill holes at each of the marked positions,
adjusting the diameter and depth of the holes to the
screws used.
Place the machine on the workbench and insert
the screws into the mounting holes.
Firmly tighten the screws.
REPLACING A GRINDING WHEEL
To replace the dry grinding wheel, proceed as
follows:
Remove the wheel guard (3).
Loosen the nut (11).
Remove the outer flange (12) and the old grinding
wheel (2).
Clean the flanges (12 & 13).
Place a new grinding wheel.
Place the outer flange against the grinding
wheel and place the nut onto the spindle.
Securely tighten the nut.
Replace the wheel guard.
To replace the wet grinding wheel, proceed as
follows:
Remove the water reservoir (10).
Loosen the nut (15).
Remove the outer flange (16) and the old grinding
wheel (9).
Clean the flanges (16 & 17).
Place a new grinding wheel.
Place the outer flange against the grinding wheel
and place the nut onto the spindle.
Securely tighten the nut.
Replace the water reservoir.
Always unplug the tool
before replacing a grinding
wheel.
Never use a cracked
grinding wheel.
Immediately replace a
cracked grinding wheel.
A cracked grinding wheel
may break into pieces when
used and cause accidents.
MOUNTING AND ADJUSTING THE SPARK
GUARD
The spark guard needs regular adjustment in order
to compensate the wear of the grinding wheel.
Loosen the nut (19) and remove the screw (18).
Hold the spark guard (4) against the wheel guard
(3) as shown.
Mount the spark guard (4) to the wheel guard (3)
using the nut (19) and the screw (18).
Adjust the distance between the spark guard and
the grinding wheel (2) to the smallest possible
value, with a maximum of 2 mm.
Tighten the spark guard.
Slide the screen (5) to the front.
Tighten the nut (20).