Consort C861, Manual

Page: 11 / 40

7
C861 • C862 • C863 • C864 • C868 C861 • C862 • C863 • C864 • C868
8
Data-logging
1. Select [MENU] by pressing MODE .
2. Select [DATALOGGER] and press CAL .
Start the data-logging:
1. Select [STORE] and press CAL .
2. Select [ACTIVATE] and press CAL .
3. Decide whether data-logging should be carried out or not and press CAL .
4. Select [INTERVAL] and press CAL .
5. Select the desired time interval between the data-logging and press CAL .
6. Select [NUMBER] and press CAL .
7. Select the desired number of values to be data-logged and press CAL .
8. Return to the measurements.
9. Starts the data-logging according to the previous settings while a blinking
[LOG] appears. When manual data-logging has been selected, press STORE to
put a next measurement into memory. In the meantime the display shows the
logging-number e.g. [#00027].
View the stored values on the display:
1. Select [RECALL] and press CAL .
2. Select [TABLE] or [SEND] to display or send the stored data and press CAL to
continue. Follow the instructions on the screen.
Erase the stored values:
1. Select [ERASE] and press CAL . Follow the instructions on the screen.
USB
1.
Select [MENU] by pressing
MODE
.
2.
Select [USB] and press
CAL
.
3.
Select [INTERVAL] and press
CAL
.
4.
Select the desired interval between the transmitted data and press
CAL
. Pre-
set to zero if no automatic transmitting is required.
5.
Select [IDENTIF. No.] and press
CAL
.
6.
Enter an indentification number for the transmitted data and press
CAL
.
• You can download a suitable USB driver from www.consort.be (>downloads).
Alternating measurements
1. Select [MENU] by pressing MODE .
2. Select [ALTERNATE] and press CAL .
3. Select the desired modes and press each time CAL . Eventually press CAL again
to unselect.
4. Select [START] and press CAL . The display alternates between the selected
modes with an interval of ca. 5 s. Pressing STORE will send all values of the
selected modes to the USB output.