These operating instructions are a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1,
D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, micro
fi
lming,
or the capture in electronic data processing systems require the prior written approval by the editor.
Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in
technology and equipment reserved.
© Copyright 2011 by Conrad Electronic SE.
Technical Data
a) Transmitter stick
Operating voltage .........................5 V/DC
Supported resolutions ...................480p, 576p, 720p, 1080i, 1080p
Supported audio formats ..............max. 6Mbps AC3 and DTS
PCM 2 channel audio ...................yes, 16/24bit, 32/44,1/48/96 kHz
3D transmission ............................yes
Transmission frequency................5 GHz
Transmission range ......................max. 10 m
Latency .........................................<1 ms
Dimensions ...................................83.2 x 30 x 17.1 mm (L x W x H)
Weight ..........................................26 g
b) Receiver module
Operating voltage .........................5 V/DC
Dimensions ...................................95 x 95 x 32 mm (L x W x H)
Weight ..........................................115 g
c) Wall plug transformers (2 units)
Operating voltage .........................100 - 240 V/AC, 50-60 Hz
Output ...........................................5 V/DC, 1.5 A
Handling
• Only use in dry indoor locations. The product must not get damp or wet! With the
wall plug transformers there is also the deadly peril of an electric shock!
• Never use the product immediately after it has been taken from a cold room to a
warm one. The condensation that forms might destroy your unit. With the wall plug
transformers there is also the deadly peril of an electric shock!
Allow the product to reach room temperature, before connecting it to the power
supply and putting it in to use. This may take several hours.
• Any maintenance or repair work may only be performed by an authorised repair
shop.
• Check the product for damage before each use!
If you detect any damage, DO NOT connect the product to the mains supply!
A safe operation can no longer be assumed, if:
- the product shows visible signs of damage,
- the product does not function or does not function properly (e.g. a burning smell)
- the product was stored under unfavourable conditions
• When setting up the product, make sure that the cables are neither kinked nor
pinched.
• Avoid the following adverse conditions at the installation location and during trans-
portation:
- Damp or excess air humidity
- Extreme cold or heat
-
Dust
or
fl
ammable gases, fumes or solvents
-
Strong
vibration
• If the product is not to be used for some time (e.g. during storage), unplug the
transmission stick and the receiver module from the power supply. Unplug the wall
plug transformer from the mains socket.
Declaration of Conformity (DOC)
We, Conrad Electronic, Klaus-Conrad-Straße 1, D-92240 Hirschau, hereby declare that this
product conforms to the fundamental requirements and the other relevant regulations of the
directive 1999/5/EC.
☞
The Declaration of Conformity for this product can be found at www.conrad.com.
Disposal
Dispose of an unserviceable product in accordance with the relevant statutory regu-
lations.
