These operating instructions are published by Conrad Electronic SE, Klaus-Conrad-Str. 1,
D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming,
or the capture in electronic data processing systems require the prior written approval by the editor.
Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in
technology and equipment reserved.
© Copyright 2013 by Conrad Electronic SE.
V1_0913_02-TS
Operation
Attention!
The LED table lamp is only allowed to be operated using the supplied power adaptor (5). It is
an LED converter with a constant current of 350 mA.
If a normal power adaptor is connected to the LED table lamp this is destroyed immediately.
This causes the guarantee/warranty to become invalid!
1. Place the LED table lamp on a clean, dry, horizontal and stable area.
2. Connect the low-voltage plug (6) of the table lamp with the corresponding socket on the power
adaptor (5).
3. Then insert the power adaptor (5) into a proper power point.
4. Switch the LED table lamp on using the on/off switch (1) on the underside of the lamp head (9).
5. Turn the lock nuts (2, 4) anti-clockwise to set the lamp arm (3) and the lamp head (9) to the desired
position. Hold the lamp base (7) securely with a hand and make sure that the table lamp is not
overbalanced and cannot tip over. Direct the lamp arm (3) and the lamp head (9) so that the illuminated
area is lit as well as possible. Resecure the lock nuts (2, 4) by turning them anti-clockwise.
Attention!
During operation the lamp head (9) becomes hot in the area of the LEDs (8). If you wish to
check the direction of the LED table lamp, take hold of the lamp head (9) with care – danger
of burns!
Maintenance and cleaning
• Before cleaning the LED table lamp is to be switched off and disconnected from the mains. Pull the plug
out of the power point. Then let the LED table lamp fully cool down.
• Do not use aggressive cleaning agents, spirits or other chemical solutions as they may attack the casing
or even affect the functioning of the device.
• For cleaning all you need is a dry, soft and clean cloth. Do not press too hard on the casing as this can
lead to scratches.
• On the outside the LED table lamp should only be wiped with a clean, soft and damp cloth.
• The LED table lamp is maintenance-free. The LED light is securely built-in and cannot be replaced.
Disposal
Electronic devices are recyclable waste and must not be disposed of in the household waste.
At the end of its service life, dispose of the product according to the relevant statutory regulations.
You thus fulfil the legal requirements and make your contribution to protecting the environment.
Technical data
a) LED table lamp
Total power consumption .............12 V/DC, max. 4.4 W
Illuminant .....................................9 x SMD LED (0.38 W), not replaceable
Colour temperature ......................2900 K, warm-white
Luminous flux ..............................300 lm
Cable length ................................approx. 1.8 m
Operating temperature ................0 to +40 °C
Operating humidity ......................0 - 90 % RH
Storage temperature ....................-40 to +80 °C
Storage humidity ..........................0 - 90 % RH
Radiation angle ............................104.9°
Dimensions (W x H x D) ..............170 x 550 x 105 mm
Weight .........................................1.1 kg
b) Power adaptor (LED converter)
Operating voltage ........................220 - 240 V/AC, 50/60 Hz
Output ..........................................12 V/DC, constant current 0.35 A