![background image](http://html1.mh-extra.com/html/conrad/558081/558081_operating-instructions-manual_2653986004.webp)
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau
(www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming,
or the capture in electronic data processing systems require the prior written approval by the editor.
Reprinting, also in part, is prohibited. This publication represent the technical status at the time of
printing.
© Copyright 2014
by Conrad Electronic SE.
V6_1114_02-HK
Controls
The following button functions apply both to the remote control and the touch-sensitive control
panel on the top of the product.
Button
Function
Activate heating (display lights up)
Deactivate heating (display goes out)
The device turns off approx. 10 seconds after the heating function has been deactivated
Activate/deactivate oscillating action
Push 1 x : Set the automatic turn-off function (set the length of time after which the heater
turns off automatically)
Push 2 x : Temperature setting (set the desired room temperature)
Set heating level: 1600 W (low) or 2500 W (high)
Increase value (Turn-off time/Temperature setting)
Turn-off time: 1 – 12 hours
Adjustable temperature range: +15 to +28 ºC
Decrease value (Turn-off time/Temperature setting)
Display symbols
Symbol
Meaning
1 H – 12 H
Indicates the time remaining until automatic turn-off in hours
ºC
Indicates degrees in Celsius, appears after the temperature value
Indicates low heating level (1600 W)
Indicates high heating level (2500 W)
Appears when the product is turned on via the remote control or touch-sensitive control
panel
Appears when oscillating action is activated
Notes
• The + and – buttons work only when the SET button has been pushed and the corresponding value is
blinking on the display.
• During operation, the display alternates between showing the remaining turn-off time and the current room
temperature. If the automatic turn-off function is deactivated, only the current room temperature is shown.
• The display dims slightly approx. one minute after the last button was pushed.
• Once the desired temperature has been reached, the thermostat turns off the heater temporarily. The
heater stops oscillating and the display shows only the current room temperature and the on/off symbol.
• As soon as the room temperature drops 2 °C below the set value, the thermostat reactivates the heater.
• After start-up, it takes about 10 seconds until the thermostat is operational. The heater turns on immediately
after start-up. Should the room temperature be above the set temperature (default: 25 °C), the heater may
deactivate 10 seconds after start-up.
• When the automatic turn-off function is activated, the product will switch automatically to stand-by mode
after the set turn-off time. If the time is set to 0, the automatic turn-off function is deactivated.
• The display shows LO at room temperatures below -10 °C.
• The display shows HI at room temperatures above +40 °C.
Anti-tilt and overheating protection
• The product has an anti-tilt mechanism that automatically deactivates the heating function should the
product tip. Check the product for any damage before continuing use. Set the product back up and turn it
on using the remote control or touch-sensitive control panel. Make sure the product cannot accidentally
tip over.
• The product has a double overheating protection.
- In case of improper use (i.e. if the heater vents are blocked), the internal NTC thermistor will turn off the
product automatically should the temperature inside the housing 65 °C. Once the temperature
has fallen below +62 °C, you can operate the product again as usual. This may take up to 30 minutes
depending on ambient conditions. However, before using the product again eliminate the cause that
automatically turned the product off. If you cannot determine the cause contact a professional.
- Should the NTC thermistor malfunction for any reason, the internal thermal fuse will trip should the
temperature inside the housing 113 °C.The thermal fuse does not reset, once it is tripped the
product cannot be used.
Maintenance and cleaning
Never use any aggressive cleaning agents or chemical solutions as these may cause damage to
the housing or impair the product‘s functioning.
Do not apply too much pressure to the product‘s surfaces as this may cause scratching.
• Besides occasional cleaning, the device is maintenance-free.
• Before cleaning, turn off and unplug the product. Allow it to cool down completely.
• Never submerge the product or the remote control in water.
• Use a dry, soft and clean cloth to clean the product.
• Remove any dust with a long-haired, soft and clean brush or a vacuum cleaner.
Disposal
a) Product
Electronic devices are recyclable waste and must not be disposed of in the household waste.
At the end of its service life, dispose of the product according to the relevant statutory regulations.
Remove any inserted (rechargeable) batteries and dispose of them separately from the product.
b) (Rechargeable) batteries
You as the end user are required by law (Battery Ordinance) to return all used batteries/rechargeable
batteries. Disposing of them in the household waste is prohibited.
Contaminated (rechargeable) batteries are labelled with this symbol to indicate that disposal
in the domestic waste is forbidden. The designations for the heavy metals involved are: Cd =
Cadmium, Hg = Mercury, Pb = Lead (name on (rechargeable) batteries, e.g. below the trash
icon on the left).
Used (rechargeable) batteries can be returned to collection points in your municipality, our stores
or wherever (rechargeable) batteries are sold.
You thus fulfil your statutory obligations and contribute to the protection of the environment.
Technical data
Operating voltage ............................. 220 – 240 V/AC, 50 Hz
Battery type (remote control) ............ CR2032 (not included)
Power consumption .......................... max. 2500 W (low heating level: 1600 W, high heating level: 2500 W)
Adjustable temperature range .......... +15 to +28 ºC
Automatic turn-off ............................. 1 – 12 hours
Oscillating action .............................. 80º
Suited for spaces of up to ................ 35 m
2
Noise level ........................................ <55 dB
Protection class ................................ II
Cable length ..................................... 1.5 m
Dimensions (Ø x H) .......................... 320 x 1130 mm
Weight .............................................. 3.85 kg