![background image](http://html1.mh-extra.com/html/conrad/1483574/1483574_original-operating-instructions_2653867033.webp)
33
8. Operation
a) Removing the Rechargeable Battery from the Cordless Impact Screw
Driller/Inserting It
•
To remove the rechargeable battery from the cordless impact screw driller keep the unlocking button (9) at the
cordless impact screw driller pushed and pull the rechargeable battery out forward.
•
To insert the rechargeable battery, push it into the rechargeable battery holder in the correct alignment until it
latches.
b) Inserting Tool into the Quick-Action Drill Chuck/Removing It
•
Put the rotating direction switch (4) in the middle position to block the
on/off switch (11).
•
Open the quick-action drill chuck by turning it counter-clockwise to the
left (viewed from the front) (A).
•
Insert the desired tool into the drill chuck. The diameter must be at least
1.5 mm, and at most 13 mm.
•
Tighten the quick-action drill chuck by turning it clockwise to the right
(viewed from the front) (B).
• To fasten the tool (e.g. a drill) firmly in the quick-action drill chuck, it
should be inserted at least 1 cm deep (e.g. small drills). Drills with a larg-
er diameter should be pushed as deep as possible to the quick-action
chuck to be safely held.
If the impact drill function is used, the drill must be pushed into the quick-action chuck to the stop.
c) Rotating Direction Switch (with Activation Lock)
The rotating direction switch (4) can be used to switch the rotating direction
between left and right.
A double arrow on the rotating direction switch (left (A) and right (not il-
lustrated) sides of the cordless impact screw driller) indicates the rotating
direction or whether a screw would be "turned out" or "turned in".
The rotating direction must be chosen depending on whether
holes are to be drilled or whether a screw is to be turned in or
out.
In the middle position, the rotating direction switch will block the on/off
switch and thus the motor in the cordless impact screw driller.