Chapter 4
Installing the Drive
Page 36
Filepro CFP2107 Series
Attaching Power to the Drive - CFP2107S
The drive has a 4-pin DC power connector, J4 mounted on the PCB. The
recommended mating connector is AMP part number 1-480424-0 utilizing AMP
pins, part number 350078-4 or equivalent.
Connect the DC Power cable to the drive as shown in Figure 4-5.
Attaching a Remote LED - CFP2107S
J3, pin 3
or J6 pin 10
J3, pin 4
or J6, pin 9
A remote LED can be attached using a 0.1
inch center, 2-pin connector to pins 3 and 4 of
J3. The anode of the LED should be
connected to pin 3 and the cathode to pin 4.
An external LED can optionally be attached
using a 2mm center connector on J6, pins 9
and 10 (location OE6). The anode of the LED
should be connected to pin 10 and the cathode
to pin 9.
The external LED is connected in parallel to
the on board LED and is powered through a
200 ohm current limiting resistor to the +5
volt power.
Mounting the Drive - CFP2107S
The drive is designed to be used in applications where the unit may experience
shock and vibrations at greater levels than larger and heavier disk drives will
tolerate.
The design features which allow greater shock tolerance are the use of rugged
heads and media, a dedicated landing zone, closed loop servo positioning and
specially designed motor and actuator assemblies.
Mounting Screw Holes
Six side, or four bottom base mounting points are provided to the customer. The
drive is mounted using 6-32 UNC -2B X 0.16 maximum insertion length screws.
Refer to Figure 2-3 in Chapter 2 for the location of the mounting holes. The
drive may be mounted in any orientation.
Cooling
The enclosure design for the drive must provide adequate provision for removing
heat generated by the drive via conduction or air flow convection cooling. The
maximum operating temperature for the drive is 55°C. A temperature sensor
