6
www.c2vision-eu.com
Connecting Aftermarket Video Sources
1
2
INSTALLATION
1. Connect the CAM-LR6-AD’s analogue power supply to the interface box.
*If no LED on the interface lights up with ignition on, then the single red wire (ACC-Out)
and the purple wire (Manual ACC) will need to be connected together.
2. When connecting of a rear view camera to the CAM-LR6-AD, connect the
cameras RCA connection to the “Camera IN” RCA on the harness.
3. If the video interface receives a signal of reverse gear, then leave the green
“In” & “Out” wires connected so that the interface is able to automatically
switch to the rear-view when reverse gear is engaged. If the interface does not
deliver a source of 12V via the CAN-Bus, then the “Reverse In” wire will need to
be connected to a source of reverse (ideally the reverse light).
4. The 2x “Video IN” RCA connections can then be used to connect alternate
video sources (DVD, DVBT etc.)
Note: this interface is only able to insert video signals, not audio. If an audio source is
connected, the audio will need to be routed via means of the factory AUX input or an
FM-modulator (sold separately).
5. Connect the external keypad via the 4-pin molex connector to the harness.
By pressing the button you are able to switch through any enabled sources like
so:
Factory video
→
Video IN 1
→
Video IN 2
→
Factory Video
Note: dependent on vehicle, you are able to switch the video view through the original
radios ‘home’ button (or by holding the top left of the touch screen). If you are able to
use factory radio buttons, the keypad still needs to be connected for support purposes.
*
4
4
3
5
