9
2. INSTALLATION
To properly install the Managed Industrial Gigabit Ethernet Switch, please follow
the procedures listed below. Procedures covered in this chapter are described
below in separate sections.
Installation Requirements
Unpacking the Managed Industrial Gigabit Ethernet Switch
Installing the Managed Industrial Gigabit Ethernet Switch
Powering on the Managed Industrial Gigabit Ethernet Switch
Connecting the Managed Industrial Gigabit Ethernet Switch to the
Network
2.1 Installation Requirements
ATTENTION
Be sure to power off before installing or wiring your Managed
Industrial Gigabit Ethernet Switch.
Be sure to calculate the maximum possible current in each
power wire and common wire. If the current goes above the
maximum ratings, the wiring could overheat, causing serious
damage to your equipment.
Be sure to read and follow important guidelines as below:
Do not run signal or communications wiring and power wiring through
the same wire conduit. Wires with different signal characteristics
should be routed separately to avoid interference.
It is recommended that wiring which shares similar electrical
characteristics can be bundled together.
Keep input wiring and output wiring separate and label the wiring to all
devices in the system if necessary.
2.2 Checking the Package Contents
Unpack the package carefully and check the package contents. The standard
package should contain the following items:
1 Managed Industrial Gigabit Ethernet Switch
1 Documentation CD
