CP-CURVE STEP-AG 11-12
8
Safety Information
1) Always follow the manufacturerʼs
recommendations for the safe use of all hand
tools and equipment.
2).
Do not
use the Confer Curve Step for any
purpose other than that for which it is intended.
3). When lifting awkward or heavy loads, have
another person help you.
4). Maximum weight on steps
not
to exceed
400
lbs.
5).
WARNING:
Exceeding the recommended weight
restriction may cause the unit to fail.
6). Consult your local building department before
installation of your pool and equipment.
TO WINTERIZE YOUR POOL
We suggest removing your Confer Curve Step from the pool
for the off-season months.
If your Confer Curve Step is attached to a deck: Two people
are required for this operation and it is best to remove the
unit while the water is still warm enough so that one person
can get into the pool. Disconnect the mounting brackets
from the deck. The person in the water can lift the unit up
while the person on the deck helps to pull and guide the unit
onto the deck. After the unit is on the deck, and the water
has drained out of the steps, lay the unit on itʼs back side so
that most of the water drains from the side panels.
If getting into the water is not an option the unit can be
removed by both people standing on the deck and lifting and
tilting the unit to drain some of the water from the steps. After
the unit is light enough carefully lift it from the pool.
CAUTION: POOL STEP WILL BE HEAVY, PLEASE HAVE
ADDITIONAL HELP WHEN REMOVING FROM
SWIMMING POOL. DO NOT ATTEMPT TO REMOVE
STEP BY YOURSELF.
The Confer Curve Step can be covered, if desired, and
stored outdoors.
Printed in U.S.A.
MADE IN THE U.S.A. by:
CONFER PLASTICS, INC. FIVE YEAR WARRANTY
Confer Plastics, Inc. warrants their swimming pool ladders and steps to be free from defects in
workmanship for five years from date of purchase.
DO NOT RETURN DEFECTIVE PART TO DEALER
E-MAIL CONFER PLASTICS AT:
A PICTURE [S] OF DEFECTIVE PART, A BRIEF DESCRIPTION OF PROBLEM,
PROOF OF PURCHASE AND YOUR CONTACT INFORMATION.
INFORMATION MAY ALSO BE FAXED TO CONFER PLASTICS AT:
716-694-3102
OR MAILED TO THE ADDRESS BELOW. UPON REVIEW OF THE INFORMATION YOU
WILL BE NOTIFIED IF PART IS COVERED UNDER THE WARRANTY AND
THE SHIPPING/HANDLING CHARGES.
This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state.
Confer Plastics, Inc.
97 Witmer Road
North Tonawanda, N.Y. 14120-2421
97 Witmer Road
North Tonawanda, New York 14120-2421
Toll Free U.S. 800-635-3213
FAX 716-694-3102
www.conferladders.com
prpd.Confer-CurveStepAG-USr11:Confer-Step-1_R1 2/19/13 2:55 PM Page 8
