Conergy SunEasy Grid Connect Kit - User Manual
8
Rev 0 - 0704
Heat build-up
Exercise caution when touching the inverter housing. The inverter can become hot during use. Never cover the
inverter’s heat sinks or vents when it is in use. Please observe the distances around the inverter as laid out in the
operating instructions.
Dust formation
Do not allow excessive dust to build up around the inverter. Never touch damaged cables; report the damage to
your Conergy SunEasy installer immediately.
AC circuit breaker
Recurrent tripping of the AC circuit breaker indicates a fault. Please report this fault to your Conergy SunEasy power
system installer immediately.
Inverter display
Regularly check the inverter display and report any malfunctions or warning signals.
Operating instructions
Please refer to the enclosed operating instructions for further safety information on your inverter and instructions for
displaying your system performance data.
Warning notices
Safety Signs and Instructions
All safety instructions and warning signs installed with the system:
• Must be kept in a legible condition
• Must not be damaged
• Must not be removed
• Must not be covered, pasted or painted over
DC disconnecting device
DO NOT disconnect the inverter’s DC side when the inverter is
switched on or when solar panels are producing energy.
DC plugs must never be disconnected from the sockets of the solar modules as long as the Conergy WR unit is
feeding power into the mains. Before disconnecting the DC plug you must always disconnect AC power to the
inverter.
To carry out maintenance work, your installer needs to switch the system off via the AC circuit breaker Q1 and then
disconnect the DC side, as per the shutdown procedure.