5
Mount the projector
11
Mount the projector plate to the
projector. Start by placing the 0.8"
plastic spacers on all 4 inserts.
Place the 0.5" rubber buffers on top
of the plastic spacers and finally put
the washers on top.
4 x distance tube 20 mm
4 x rubber buffer 13 mm
4 x washer 8 mm
Adjust the projector
Picture is too small or too big:
To increase picture size loosen the adapter
E
and slide it
over the tube away from the board. To decrease picture
size move the projector towards the board. Tighten all
screws securely afterwards.
Horizontal keystone correction:
Loosen the adapter
E
and turn the projection to the right side if the picture is too small in the right
side. Turn the projector the other way around, if the picture is too small in the left side.
Vertical keystone correction:
If the picture is bigger at the top than at the bottom, secure the screws
C
and
D
or loosen the screws
A
and
B
at the same time. If the picture is smaller in the top than in the bottom, tighten
A
and
B
or loosen
C
and
D
.
Picture is not centered:
Loosen the screws
A
,
B
,
C
and
D
. Move the projector in the right direction.
Tighten all screws again.
Picture is not straight:
If the picture does fall down the left side, tighten the screws
A
and
C
and loosen the screws
B
and
D
. If the picture does fall down the right side, tighten the screws
B
and
D
or loosen the screws
A
and
C
.
14
B
A
C
D
E
13
12
Carefully place the projector plate on
top of the spacers and washers and
secure the plate with 4 x allen head
screws M4 x 45 (0.15" x 1.8").
Attach the bracket, which will hold
the projector to the projector arm, to
the projector plate with 4 x allen head
screws M6 x 10 (0.24" x 0.39").
Do not tighten the screws yet.
Attach the projector to the arm and
tighten the screws.
work
IT
desk
interactive ta
ble
