work
IT
desk
interactive table
5
13
Mount the projector
11
Mount the projector plate to the
projector.
Start by placing the 0.5" rubber
spacers over the 4 mounting holes.
Place the metal washers on top.
4 x rubber buffer 13 mm
4 x washer 8 mm
Adjust the projector
Picture is too small or too big:
To increase picture size loosen the adapter
E
and slide it
over the tube away from the board. To decrease picture
size move the projector towards the board. Tighten all
screws securely afterwards.
Horizontal keystone correction:
Loosen the adapter
E
and turn the projection to the right side if the picture is too small in the
right side. Turn the projector the other way around, if the picture is too small in the left side.
Vertical keystone correction:
If the picture is bigger at the top than at the bottom, secure the screws
C
and
D
or loosen the
screws
A
and
B
at the same time. If the picture is smaller in the top than in the bottom, tighten
A
and
B
or loosen
C
and
D
.
Picture is not centered:
Loosen the screws
A
,
B
,
C
and
D
. Move the projector in the right direction.
Tighten all screws again.
Picture is not straight:
If the picture does fall down the left side, tighten the screws
A
and
C
and loosen the screws
B
and
D
. If the picture does fall down the right side, tighten the screws
B
and
D
or loosen the
screws
A
and
C
.
14
B
A
C
D
E
The clamp below (attached with
blue-circled screws) should be
shifted all the way to the RIGHT
position.
Do not tighten the screws yet.
Move projector out to the farthest
distance from the table.
12