SERIES CHARGING CONTACTS MANUAL
8
SECTION 1 - SAFETY
Electrical Warning
Instal the charging contact system in accordance with the National Electric Code (NEC) or local codes and/or ordinances applicable in your
region.
WARNING
Hazard of Electrical Shock or burn.
Always disconnect the power before attempting to perform any service function. Follow lock out/
tag-out procedures as outlined in OSHA section 1910.147 where appropriate.
Do not use charging contacts with electrical loads greater than the rated current and voltage. Information regarding the current and voltage
rating of each contact is recorded on the component type label. Further details can be found in the product catalog.
Operational Warnings
Means of final installation and integrations of this equipment are the responsibility of the OEM integrator. Modification of this equipment
may cause excessive wear or failure and will void the warranty. Modification may cause safety and fire hazards, the end user takes sole
responsibility for any modifications made to the product and in doing so absolves Conductix-Wampfler from any liability.
Maintenance Warnings
Exercise care while installing, servicing, adjusting, and operating the charging contacts and charging system. Periodically check all
fasteners and hardware to ensure they are properly tightened. Reference the drawing provided with the product for fastener torque
specifications. If you have any questions concerning the use or installation of your product, contact the factory:
•
North & South America: +1 (800) 521-4888
•
Europe & Asia: +49 7621 6620
Specifications and Listings
The charging contact products are built to comply with UL and IEC specifications and standards, but are not generally certified or listed by
an independent body.
All charging contact products conform, as applicable, to the following standards:
•
IEC 60204-1 Electrical equipment of machines-PELV device
•
EC 60364-4-42 Protection against thermal effects
•
IEC 60644-1 Insulation coordination for equipment within low-voltage systems
•
IEC 60999-1 Safety requirements for screw-type and screwless-type clamping units
•
IEC 61140 Protection against electric shock – PELV device
•
UL 840, UL 746C, UL 583
Some charging contact products may be CE listed, please consult the factory for additional details.
Temperature, Voltage, and Ampere Ratings
The charging contact products are rated to withstand a maximum operating temperature of 120° C (248° F) and minimum operating
temperature of -30° C (-22° F). The current and voltage rating of each contact is recorded on the component type label. Further details
can be found in the product catalog. Charging contacts can be supplied with a large variety of connections, voltage ratings, and ampere
ratings. Consult the factory for additional details.
Product Markings
Each base plate and vehicle collector is marked with a type label containing the Conductix name and logo, the product catalog number,
and the voltage and ampere rating for the product.
