CONDTROL 3-17-023, Manual

Page: 13 / 25

24 25
User manual
THERMAL IMAGER
IR-CAM1 CONDTROL
User manual
THERMAL IMAGER
IR-CAM1 CONDTROL
CARE AND MAINTENANCE
Attention!
This product is an accurate optical and electronic device and requires delicate
handling. If the device is given to somebody for temporary use, be sure to enclose user manual
to it.
It is prohibited to point the device at the sun and other sources of intense radiation (for
example, objects whose temperature e1000 ° C). It may cause a serious damage of the
sensor. The manufacturer is not responsible for this type of damage of microbolometer sensor.
The actual temperature of the object may differ from the measurement result of the device.
The examined surfaces may be potentially dangerous. Measured objects or a measurement
environment may also present a certain risk.
The user should follow the safety rules set by particular industry.
Observation of the following recommendations will extend the life of the device:
- protect the device from bumps, drops, excessive vibration; do not allow moisture, construction
dust, foreign objects get inside the product;
- if moisture gets inside the device, please contact service center;
- do not store or use the device in high humidity environment for a long period of time;
- Do not store the product in locations where temperature is less than -10°С. After storage in
low temperature conditions and subsequent transfer to a warm room, the device is heated,
causing moisture condense inside the product and damage microcircuits.
- Keep the device away from direct sunlight and avoid its prolonged exposure to the sun and
high temperatures.
- Clean the device with a soft, damp cloth moistened with soapy water. Do not use cleaning
solvents or abrasives.
UTILIZATION
Expired tools, accessories and package should be passed for waste recycle. Please send the
product to the following address for proper recycle:
CONDTROL GmbH
Wasserburger Strasse 9
84427 Sankt Wolfgang
Germany
Do not throw the product in municipal waste!
According to European directive 2002/96/ЕC expired measuring tools and their components
must be collected separately and submitted to environmentally friendly recycle of wastes.
WARRANTY
All CONDTROL GmbH products go through post-production control and are governed by the
following warranty terms. The buyer’s right to claim about defects and general provisions of
the current legislation do not expire.
1) CONDTROL GmbH agrees to eliminate all defects in the product, discovered during the
warranty period, that represent the defect in material or workmanship in full volume and at
its own expense.
2) The warranty period is 24 months and starts from the date of purchase by the end consumer
(see the original supporting document).
3) The Warranty doesn’t cover defects resulting from wear and tear or improper use,
malfunction of the product caused by failure to observe the instructions of this user manual,
untimely maintenance and service and insufficient care, the use of non-original accessories
and spare parts. Modifications in design of the product relieve the seller from responsibility
for warranty works. The warranty does not cover cosmetic damage, that doesn’t hinder normal
operation of the product.
4) CONDTROL GmbH reserves the right to decide on replacement or repair of the device.
5) Other claims not mentioned above, are not covered by the warranty.
6) After holding warranty works by CONDTROL GmbH warranty period is not renewed or
extended.
7) CONDTROL GmbH is not liable for loss of profit or inconvenience associated with
a defect of the device, the rental cost of alternative equipment for the period of repair.
This warranty applies to German law except provision of the United Nations Convention on
contracts for the international sale of goods (CISG).
In warranty case please return the product to retail seller or send it with defect description to
the following address:
CONDTROL GmbH
Wasserburger Strasse 9
84427 Sankt Wolfgang
Germany