8
Note: Do not push the pivot into the bracket. (figure-5)
4. Initial installation of transducer
a) Apply marine sealant to the 4 x 15mm screws and the two holes on transom. Hold the
bracket against transom again slightly tighten the template by two 4 x 15 mm screws
(figure-6).
Note: Do not over tighten, otherwise you will not being able to adjust the transducer
b) Adjust the template to make it roughly vertical to the water surface
，
then tighten the two
screws with Allen wrench
c) Press the pivot into the bracket, and then rotate the transducer to make it parallel with
the water surface.
Note: The pivot match the transducer by ratchets and the increment is 12 degree, so in
some situations you may find it impossible to adjust the transducer completely parallel with
the water surface. In this situation a slight inclination downward (1 ~ 5 degree) is
acceptable.
Figure-5
Do not push
the pivot into
the bracket
Figure-6
