Condair US 13, Operation And Maintenance Manual

Page: 44 / 74

44 | Maintenance
2588787_B_EN_2005_US_OM
US
8.4.1 Removing and Installing the Door Panels
Removing the Door Panels
Remove the two door panels in the humidifier as follows. Refer to Figure 15 below .
1.
Turn the captive screw in each door panel counter-clockwise with a screwdriver.
2.
Lift up the door panel slightly so that the tabs clear the notches in the cabinet, then carefully remove the
panel.
Installing the Door Panels
Install the two door panels in the humidifier as follows. Refer to Figure 15 below .
1.
Position each door panel so that the two tabs in the top rear of the panel align with the notches in the
cabinet.
2.
Lower the door panel to seat the tabs in the notches, while ensuring that the long tab on the side of the
panel slides behind the stationary panel.
3.
Make sure that the door panel fits flush on the front and the side. Turn the captive screw in the door panel
clockwise with a screwdriver to secure the door panel. Check that it is fastened securely.
1
2
3
4
5
7
6
Figure 15 - Door Panel Removal and Installation
1.
Stationary panel
2.
Door panel, control cabinet
3.
Captive screw
4.
Door panel, plumbing cabinet
5.
Top tab, door panel
6.
Long tab, door panel
7.
Notch, cabinet