W4 Limiter Sensor Broken
Limiter sensor input (transducer or WiFi) is broken or not wired properly.
- yellow
For a transducer input signal, this warning will appear if the value of the transducer or WiFi signal is 5% of the full
signal.
Check the connections between the humidifier and its sensors. This warning may indicate improper wiring, or a
blocked wireless signal. Reduce the length of wire between the humidifier and the sensor(s), or extend the range
of your wireless device, or remove obstructions between the humidifier and wireless access point.
W5 Replace Cylinder Imminent
The cylinder will soon be expired.
- yellow
- yellow
The unit will continue to run for approximately one-three weeks once this warning appears, depending on the
condition of your water. After this period, warning W5 will upgrade to fault, E5 Replace Cylinder, and the unit will
not operate.
When ordering the replacement cylinder, ensure that the model number is correct.
Replace the cylinder then reset the warning or fault status.
W6 WiFi Signal Timeout
No WiFi signal received.
- red
- yellow
This warning appears when the humidifier is set to receive a WiFi control signal, but a WiFi signal is not received.
The timeout occurs if this period is greater than 300 seconds.
Ensure that your WiFi set-up is working correctly, and is not interrupted by any obstructions.
Restart the humidifier, turning it off and then on again.
Reconnect the humidifier to your device. You may need to remove the device first, and then add it again.
n
Press and hold the power button for 5 seconds.
n
On the HumiLife app, press
Add device
.
Condair RH
2594949_B_EN_2005_Condair-RH_OM
Troubleshooting | 29
Summary of Contents for HumiLife RH Series
Page 31: ...Page intentionally left blank...
